An off-road builder named Zeph Gage has put a portal axle on the rear of his Jeep XJ for roughly a fifth of what a commercial set typically costs, combining a Ford 9-inch housing, Humvee geared hubs and a differential turned upside down.
Portal axles replace the usual arrangement of shafts and drivetrain parts hanging below the frame with a stack of gears behind each driven wheel. That lets the axle shafts sit much higher, so very little hardware hangs below the frame line. Paired with tall tires, the design buys substantial clearance for working over rock and other obstacles. The drawback is price: a typical set from companies such as 74Weld runs about $20,000.
How the budget version works
Gage's build uses geared hubs from a Humvee, a Ford 9-inch axle housing and a set of Jesse Haines Fabrication HMMWV portal adapters. The Humvee's two-gear portals reverse the rotation of the input shaft, which would otherwise spin the driveline the wrong way. To correct that, Gage flipped the differential upside down so the driveline turns in the proper direction and bolted a Yukon Gear and Axle third member to it. The result is effectively a high-pinion unit assembled from low-pinion parts that have simply been turned over.
The arrangement adds about six inches of clearance. It also preserves full shock travel, which is described as tricky to achieve with portal axles, and reduces stress on the differential itself, so the assembly should be effectively bulletproof as a result.
Why only the rear
Installing a portal axle at the back without upgrading the front is a common trick in the remote-control rock crawler scene. Keeping the solid axle up front meant Gage did not have to solve the packaging constraints that usually appear when portal axles are fitted to a vehicle that never had them from the factory. It also avoided restricting shock travel to work around those constraints, and it kept the ride height from climbing absurdly high. By that reasoning, the setup offers the best of both worlds.
The trade-off is fabrication. This is not an off-the-shelf solution: Gage made his own brackets and custom-tapped plates, and used a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it carries an integrated electric emergency-brake solenoid and partly, again, for clearance.
What it delivers
The finished Jeep can drive over a five-gallon bucket and still have several inches of clearance to spare. That means the rear end is less likely to hang up on obstacles the front end can simply steer around.
The build took considerable thought to get right, but the outcome is judged worth the effort. More specifics, including how Gage matched gearing between the front and rear axles, are covered in a video from Outdoor Auto.
