Automotive Accessories

Tremec Manual C8 Development Car Shows Clutch-Pedal Fit and Cost Tradeoffs

A track drive of Peitz Performance’s one-off C8 race car reveals a functional manual transaxle, a remote shifter with altered feel and a gearbox cost of about $75,000.

Sofia MarchettiNovember 17, 20265 min read1 views

A cutaway-style illustration of a mid-engine sports car showing a manual transaxle, cable-linked shifter and added clutch pedal on a private test track.

Tremec has built a running manual-transmission development car based on the mid-engine Chevrolet Corvette C8, and a track drive shows both how neatly a clutch pedal can fit and how much the conversion still costs.

The C8 was a major change for Chevrolet: it moved the engine behind the driver and became the first Corvette offered only with a dual-clutch automatic. Developing two new transaxles—one manual and one automatic—was not in GM’s budget. The automatic path delivered a highly capable Corvette and comparison-test performance against more expensive cars, but some drivers would still trade a little straight-line or lap-time performance for manual operation.

Tremec, known for the TR-6060 six-speed used in GM performance models including the Blackwing cars and the Camaro, built the manual C8 development car. It invited a reviewer and several potential customers to sample its transmissions at Motorsports Gateway, a new private track outside Howell, Michigan. The vehicle provided was the Peitz Performance C8 race car, a one-off build fitted with Tremec’s manual gearbox.

The car was a track build rather than a finished road car. Its interior fit and finish was essentially absent, the selector emerged from the space normally used for the storage cubby and automatic gear selector, and the cabin had a full roll cage and harness. The seating position had little adjustment and was set for a taller driver; the 5-foot-7 reviewer found heel-and-toe difficult because he could not reach the floor or brace himself easily in corners. Conditions—a green track on a November afternoon in Michigan—also limited how hard the car could be pushed.

Fitment and shifter feel

Peitz did not have to make major changes to the car to install the gearbox. The tunnel was cut to fit the clutch-pedal hardware, but the manual transaxle otherwise sat where the standard dual-clutch unit would, with no special mating hardware. The C8’s pedal box had enough room for the clutch, and even with a third pedal it felt roomier than a previous-generation Camaro’s footwell.

The shifter is remotely mounted, with a cable running aft to the transaxle. That makes it feel different from a front-engine car with a TR-6060, where the selector is mechanically connected directly to the transmission. The transaxle shift action was less precise and less crisp than its front-engine counterpart, and also less notchy. Some drivers may prefer the smoother feel; others may miss the more mechanical sensation. The packaging leaves two ways to change the relationship: move the engine forward, which would effectively produce a C7, or move the shifter rearward, placing the driver near the C8’s engine bay.

Cost and OEM interest

The manual conversion is not cheap. Tremec’s gearbox alone costs about $75,000, and combining that with the price of a Corvette puts a manual C8 build in the same territory as a showroom-spec Z06. Tremec says the price should fall as volume rises. The company also says OEMs are interested, not necessarily or exclusively GM; other automakers have reportedly sought a high-torque manual transaxle, though no names were disclosed.

The development car therefore shows that a manual transaxle can be packaged into the C8 with relatively modest structural changes. It also shows the limits: the remote shifter changes the feel, the conversion is expensive at low volume, and the test car was a dedicated race build rather than a production-ready conversion.